Dimensions: 34/36 (38/40) 42/44
You will need: 500 (550) 650 g of gray-beige yarn (40% viscose, 30% cotton, 20% flax, 10% polyamide; 125 m / 50 g); Knitting needles number 4 and 4.5; hook number 4; 4 white buttons with a diameter of about 23 mm.
Patterns for knitting a women's jacket with knitting needles
Openwork pattern: the number of loops is a multiple of 10 + 1 + 2 chrome. Knit according to the scheme, which are given the front rows. In the purl rows of the loop knit on the pattern, nakida - purl. Start with 1 chrome. and loops before rapport, rapport constantly repeat, finish loops after rapport and 1 chrome. Run 6 times of the 1–20th row, then run 1 time of the 21–30th row = 130 rows.
The front smooth surface: front rows - front loops, purl rows - purl loops.
Shawl: facial and purl rows - facial loops.
Flat loop pattern: an even number of loops. Each row start and finish 1 chrome. 1st + 2nd rows: front surface. 3rd row: * 2 facial, 1 nakid, from * constantly repeat, 2 facial. After the 3rd row, the number of loops is a multiple of 3 + 2 + 2 chrome. 4th row: knit loops in purses, knit loops (= later lowered loops), knit loops with facial loops. 5th row: * 2 facial, 1 purl, from * constantly repeat, 2 facial. 6–42th rows: knit loops according to the pattern. 43rd row: reset every 2nd purl loop and dissolve to the bar, continue to work on the remaining hinges according to the pattern. 44–60th rows: knit loops according to the pattern. 61th row: discard the remaining purl loops and dissolve the stitches to the strap, and knit the remaining loops according to the pattern. 62nd row: purl loops. Run 1 time 1–62 th row.
Underlined increments 1 loops in the front rows : at the beginning of the row = chrome., 1 front, 2 loops knit together the front; at the end of the row = knit according to the pattern until the last 4 paragraphs, then 2 paragraphs, knit together the front one with a tilt to the left (= 1 point. Remove as front, 1 front, then stretch it through the removed loop), 1 front, chrome.
Underlined increments of 2 loops in the front rows : at the beginning of the row = chrome., 1 front, 3 points. Knit together the front; at the end of the row = knit according to the pattern up to the last 5 points, then 3 points. knit together the front one with the broach (= 1 remove the loop as the front one, 2 knit the front loop together and pull it through the removed loop), 1 front, chrome.
Knitting density Openwork pattern: 19 p. And 30 p. = 10 x 10 cm; The front surface: 20 p. And 30.5 p. = 10 x 10 cm; Pattern with lowered hinges (after unfolding of lowered hinges): 17.5 p. And 24 p. = 10 x 10 cm
Description of knitting openwork jacket knitting needles
The back: on the spokes number 4.5, dial 83 (93) 103 points and tie up 1 purl row with facial. This series is not taken into account in subsequent calculations. Continue the work with an openwork pattern. After 40 cm = 120 rows from the initial row, close for the armholes on both sides 1 x 2 points, then in each 2nd row close 1 x 2 points and 2 x 1 points, then in the next 4th row close more 1 x 1 p. = 69 (79) 89 p. At the same time, after 43.5 cm = 130 rows from the initial row, continue working on all the loops on the front satin stitch. After 15.5 cm = 48 rows (17 cm = 52 rows) 18.5 cm = 56 rows from the change of the pattern, close the neck for the average 33 (37) 41 points and finish both sides separately. For rounding along the inner edge, close each 2nd row 2 x 1 section. After 17.5 cm = 54 rows (19 cm = 58 rows) 20.5 cm = 62 rows from the pattern change, close the remaining 16 (19) 22 n shoulder
Left shelf: on the needles No. 4.5, dial 43 (48) 53 p. And tie 1 purl row to the front. Continue the work with an openwork pattern. Attention: for the 2nd size, finish with the 1st loop after rapport and 1 chrome. Instead of 1 section with a double tilt to the left in the 19th row of the scheme (grayed out), knit 2 sections with the front one tilted to the left. Pass along the right edge of the work to perform, as on the back = 36 (41) 46 p. After 43.5 cm = 130 rows from the initial row, continue working on all loops on the front satin stitch. After 4.5 cm = 14 rows (6 cm = 18 rows) 7.5 cm = 22 rows from the pattern change, close the neck on the left edge of the work 1 x 10 (11) 12 p., Then close in each 2nd row 1 x 3 (4) 5 points, 1 x 2 points and 3 x 1 points, then in each 4th row 2 x 1 points. At the height of the backrest, close the remaining 16 (19) 22 points of the shoulder.
Right shelf: knit the same as the left shelf, but in mirror image.
Sleeve:dial on needles No. 4 for each sleeve by 42 (46) 50 p. and for a slat tie 1.5 cm = 5 rows of garter stitch, starting from 1 purse row. Continue work on the needles No. 4.5 with a pattern with lowered hinges, while in the 1st row evenly add 12 (14) 16 p. = 54 (60) 66 p. After the 3rd row from the strap on the needles 79 (88) 97 p. Through 26 cm = 62 rows from the strip (on the needles 54 (60) 66 p.) Continue work on all the loops on the front satin stitch. Simultaneously add for the bevel of the sleeves on both sides in each 8th row from the pattern change 3 x 1 p. And in the next 10th row 1 x 1 p. = 62 (68) 74 p. 12.5 cm = 38 rows from the change of the pattern, close the sleeves for the sleeves on both sides 1 x 3 points, then in each 2nd row emphasize 1 x 2 points and 7 x 1 points, then in each 4th row decrease 3 x 1 points and again in every 2nd row 6 x 1 n. and 1 x 2 n.
Assembly: perform shoulder seams. Sew the sleeves, complete the side seams and the seams of the sleeves. Straight sides of the shelves and the edge of the neckline tie 1 next to Art. b / n, while at the corners of the neck to perform 3 tbsp. b / n in 1 base loop and at the same time perform 4 p. for buttons on the right shelf (= for each loop, skip 1.5 cm of the edge with 4 air p.). The lower loop should be made at a distance of 11 cm from the bottom edge, the remaining 3 sections - with an interval of 4 cm. Then, on all the loops, link another 1 row in a “slithering step” (= Art. B / n, run from left to right). Sew buttons.