11 March, 14:28

Knitting Pullover Model 2018

Of the models of 2018, this knitted pullover shows an interesting mix of patterns, the main one of which is a wide “braid”. 3/4 sleeves are a continuation of the front and back. An excellent addition to the pullover will be mitts.

Description of knitting pullover for sizes: 36/38 (40/42); mitts are 26 cm high

You will need: yarn (65% polyacryl, 17% wool, 10% polyamide, 8% alpaca wool; 90 for mitts - 50 g camel; needles No. 6; circular needles No. 6 with a length of 40 cm.

Knitting pullover model 2018

Gum: alternately 1 persons., 1 out.

Cross-stitch pattern: 1st and 2nd rows: 2 s. Purl satin, 11 s. Facial satin stitch, 2 s. Purl satin.

3rd and 4th rows: 2 s. Purl satin, 11 s. Garter stitch, 2 s. Purl satin. In height, repeat from the 1st to the 4th row.

Patterns A, B, and C: knit according to the above patterns A, B, and C, knit the loops in purl rows according to the pattern. On patterns A and B repeat from the 1st to the 14th row, on the pattern C - from the 1st to the 16th row. In width, start with loops in front of the right arrow, repeat rapport 2 (3) times (- 7 points between the arrows), finish with loops after the left arrow. A more detailed distribution of loops is provided in the instructions.

SCHEMA 1 :

SCHEMA 1 :

Knitting density: 20 points x 25 p. - 10 x 10 cm, connected with patterns A or B: 15 p. Of pattern in transverse hem - 7 cm in width, 30 p. Of pattern C = 12 cm in width; 18 p. X 22 p. - 10 x 10 cm. Connected by the front surface.

Description of knitting pullover:

Back: dial 104 (118) p. And for the bottom bar, starting from the purl row, knit 7 cm - 19 p. rubber band. Next, distribute the loops in the following sequence: chrome., 21 (28) section with pattern A, 15 section with pattern in transverse hem, 30 section with pattern C, 15 section with pattern in transverse scar, 21 (28) section with pattern B, chrome After 32 (34) cm - 82 (86) p. from the plank add on both sides for the sleeves 1 p., then additionally dial in each 4th p. 2 times in 1 p., In every 2nd p. 2 times for 1 p., 2 times for 2 p., 1 time for 4 p., 1 time for 6 p., 1 time for 10 p. And 1 time for 27 (20) p., Added loops to include from the right edges in pattern A, from the left edge in pattern B - 216 p.
If necessary, go to the circular needles. After 24 cm - 60 p. from the first raise, temporarily leave the middle 38 points for the neckline and first finish the right side. From the inner edge close for further rounding of the neck in each 2nd p. 1 time 2 points and 1 time 1 point. Then postpone the remaining 86 points.
Finish the other side symmetrically.

SCHEMA 2 :

SCHEMA 2 :

Before: knit like a back, but for a deeper neck, temporarily leave the average 30 points already after 19 cm - 48 p. from the first increase for the sleeves and first finish the right side. From the inner edge close for further rounding of the neck in each 2nd p. 7 times 1 p. Then postpone the remaining 86 p. Finish the other side symmetrically.

Assembly: Run the seams of the sleeves and shoulder seams with a mattress
seam. For the collar, take the pending hinges of the front and back backs on the stockings with a collar, dial 16 sections along each side of the neckline rounds - 92 paragraph. Knit in circular rows.
On the loops of the pattern C, continue to knit "oblique" acc. pattern, and on the other loops knit pattern in a cross hem. After 36 krug.r. close all loops. For sleeve slats, dial on the lower edges of the sleeves in 52 (56) section and knit as follows: 7 p. facial smoothing, 1 out. a number of facial to fold, then another 8 p. facial smoothing.
Pull back the seams on the seamy side and sew. Run the side seams and bottom seams of the sleeves.

Description of knitting mitts: on the stocking needles dial 33 (36) section and distribute them in 3 needles = 11 (12) section for each knitting needle). Loops to close in a ring and to knit a front surface. For the wedge under the thumb, perform the following decreases: 1st circle: on the 1st needle to knit the 1st and 2nd points together with the front one with a slope to the left (- 1 point to remove, as in the case of knitting, 2 to knit the front of the front, then stretch it through the loop that was removed), 5 persons., 2 paragraph. to knit the front together = 31 (34)

4th circle.r .: on the 1st spoke to knit the 1st and 2nd points together with the front one with a tilt to the left, 3 faces., 2 points to knit the front together - 29 (32) points. 8th circle .r .: on the 1st spoke of the 1st and 2nd paragraphs, knit together the front one with a tilt to the left, 1 person., 2 points. knit together the front one - 27 (30) section. Then distribute the loops again: 9 ( 10) n. For each knitting needle, knit the facial surface without decreasing. After 26 cm - 58 krug.r. from a dial-up number of a loop to close freely. On the dial row, make a jumper 2 cm wide, to do this, first run a chain of ce. The second mitten is knitted symmetrically, that is, the wedge of the thumb is performed on the last 9 points on the 3rd spoke.